Yaesu DR-1X, Техническое дополнение

Страница: 1 / 113

Specifications
Exploded View & Miscellaneous Parts
Block Diagram
Connection Diagram
Alignment
Board Unit (Schematics, Layouts & Parts)
TX-MAIN Unit
PANEL-1 Unit
PANEL-2 Unit
JACK Unit
RX-MAIN Unit
RELAY-Unit
VR Unit
FILTER-Unit
DSP Unit
144/430 MHz 50 W VHF/UHF AMS DIGITAL REPEATER
DR-1X/XE
C4FM FDMA/FM
Introduction
This manual provides the technical information necessary for servicing the DR-1X/XE 144/430 MHz 50 W VHF/UHF AMS DIGI -
TAL REPEATER.
Servicing this equipment requires expertise in handing surface-mount chip components. Attempts by non-qualified persons to
service this equipment may result in permanent damage not covered by the warranty, and may be illegal in some countries.
Two PCB layout diagrams provided for each double-sided board in this transceiver. Each side of the board is referred to by the
type of the majority of components installed on that side ("Side A" or "Side B"). In most cases one side has only chip compo
-
nents, and the other has either a mixture of both chip and leaded components (trimmers, coils, electrolytic capacitors, ICs, etc.),
or leaded components only.
While we believe the information in this manual to be correct, YAESU assumes no liability for damage that may occur as a result
of typographical or other errors that may be present. Your cooperation in pointing out any inconsistencies in the technical infor
-
mation would be appreciated.
Important Note
1) This transceiver was assembled using Pb (lead) free solder, based on the RoHS specification.
Only lead-free solder (Alloy Composition: Sn-3.0Ag-0.5Cu) should be used for repairs performed on this apparatus. The solder stat
-
ed above utilizes the alloy composition required for compliance with the lead-free specification, and any solder with the above alloy
composition may be used.
2) Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
Contents
Technical Supplement