Controls & Connections
Microphone
POWER switch
VOLUME (–) switch
VOLUME (+) switch
LED Indicator
Blinking Blue: When the
BH-1
Bluetooth
®
Head-
set is correctly recognized by the
transceiver.
Blinking Red: When the
BH-1
Bluetooth
®
Head-
set is not correctly recognized by
the transceiver.
Blinking Red/Blue: Battery Voltage is Low.
PTT switch
Press this key to transmit. Release this key to return to
receive.
Earphone jack
If you use the Marine Transceiver, the
BH-1
is not pos-
sible to listen to the stereo signal.
SPEAKER
Earhook
You can wear the
BH-1
on your left or right ear.
“BH-1”
Bluetooth
®
Head Set
When the optional
BU-1
Bluetooth
®
Adapter Unit is installed, you may use the optional
BH-1
Bluetooth
®
Head-
set as a wireless link to send and receive audio to the Transceiver*.
* Check with your Vertex Standard Dealer or Catalog for applicable models.
Pairing
Before you can use your
BH-1
for the first time, the
BH-1
and the transceiver must be paired.
Refer to the
BU-1
Bluetooth
®
Adapter Unit Manual for Pair-
ing instructions.
P
Please bring the
BH-1
and the Transceiver close together
when doing Pairing.
1. Make sure that the
BH-1
is off.
2. Press and hold the POWER switch for five seconds, until
the LED indicator blinks red/blue alternately.
When the
BH-1
is correctly recognized (Requires a 20 to 30
seconds) by the transceiver, the LED indicator will blink
blue.
Effective Communications Range
The communications range between the
BH-1
and the
Transceiver is around 10m (33 ft).
Obstacles between the
BH-1
and the Transceiver may
shorten the communications distance.
If you move out of range, the beeper sounds a low pitch
tone. If you move back into range, the beeper sounds a
high pitch tone.
Turning ON and OFF
T
T
T
T
To turn the
o turn the
o turn the
o turn the
o turn the
BH-1
ON
ON
ON
ON
ON
Press and hold the POWER switch for three seconds, until
the
BH-1
’s LED indicator glows red, and the beeper sounds
a high pitch tone.
When the
BH-1
is correctly recognized by the transceiver,
the LED indicator will blink blue.
P
When the
BH-1
is not correctly recognized by the trans-
ceiver, the LED indicator will blink red.
T
T
T
T
To turn the
o turn the
o turn the
o turn the
o turn the
BH-1
OFF
OFF
OFF
OFF
OFF
Press and hold the POWER switch for five seconds, until
the
BH-1
’s red LED indicator blinks rapidly, the beeper
sounds two brief tones, and the
BH-1
turns off.
Note
Note
Note
Note
Note: The
BH-1
is automatically turned off when it is in-
serted into the
CAB-2
charger.
LED indicator
POWER Switch
BH-1 is not designed to attach to a helmet.
Specifications are subject to change without notice.
Marine Division of VERTEX STANDARD
US Headquarters
10900 Walker Street, Cypress, CA 90630, U.S.A.
www.standardhorizon.com
E
A
F
4
4
U
7
5
0
POWER Switch
All manuals and user guides at all-guides.com
all-guides.com