P 13
da Vinci
Jr. WiFi Pro
CALIBRATE
Calibration is enabled for this new extruder module.
Please update printer firmware via XYZmaker Suite before using the new extruder.
Note: Please remove print bed tape before you activate the calibration function on your printer.
Results displayed after the print bed calibration:
A. If the printer shows "CALIB COMPLETED", and
"AUTO-LEVELING IS DISABLED NOW" is displayed
on the 3rd line, it indicates that the levelness of the print
bed is good. Press "OK" to exit and print.
B. If "AUTOLEVELING IS ENABLED NOW" is displayed under
"CALIB COMPLETED", it indicates that the print bed is tilted
slightly. The printer has enabled the auto-leveling function.
Note: The auto-leveling function can improve the printing
quality, but the printing time will be longer. You can disable
this function in Settings depends on your needs.
Note: If the detection result is "FAIL", press "OK" continuously to exit. Select "INFO" > "LEVELING INFO" to check the
print bed levelness data, and contact our customer service to inform the measurement data.
1
2
3
UTILITIES
A 0317 0320 0313
B 0318 0323 0308
C 0312 0300 0440
[OK] TO RETURN
CALIB FAILED
[OK] TO CONTINUE
PLEASE CONTACT
CUSTOMER SERVICE
FOR LEVEL ISSUE
[OK] TO RETURN
Press the detection head on the right side of the print head according to the instruction of screen message,
followed by pressing OK.
PRESS SWITCH
NEXT TO EXTRUDER
[OK] TO CONTINUE
CALIBRATE
SUCCESS
AUTO LEVEL OFF
[OK] TO RETURN
CALIBRATE
SUCCESS
AUTO LEVEL ON
[OK] TO RETURN
A 0000 0000 0000
B 0000 0000 0000
C 0000 0000 0000
[OK] TO RETURN
NOTE
：
1. The stains on detection head and the top of the extruder module will affect the detection result. Before the calibration,
please remove the dirt. Please remember to install and position the extruder module.
2. If there is residue on the top of the extruder module, the detection result will be shown as below.
Please be sure to remove the dirt and recalibrate.
After detecting the print bed, the detector by the extruder module may be switched off automatically. Ensure the detector is
switched off before printing.
CALIBRATE COMPLETED
Press
Detector
