Xylem YSI 182-XT-4, Руководство по эксплуатации

Страница: 69 / 144

System 182-XT-4 Operation
4 - 5 ba76027e02 12/2014
4.3.2 Setting tables
The actual settings are made in the setting tables. Each setting is
represented by two lines together. The name of the setting appears in
the upper line on the left side of the display. The corresponding value
is in the line below on the right side.
Fig. 4-3 Example of a setting table
Operating notes

The arrows
8
/
2
appear if further display settings are above or
below the visible display range.

The toggle switch
w
is used to highlight a setting (displayed in
reverse video) and move the visible display range up or down.

To edit a setting highlight it and press
g
. The line below is
highlighted and switches to the entry mode. Depending on the
operating situation, a new submenu or a table with further relevant
settings can open up.

Break off an action and change to the next higher level with the
e
key.

Move directly to the measured value display with
m
.
Fig. 4-4 Save and quit
To accept all settings, highlight the Save and quit menu
item at the lower end of the setting table and press
g
. If
you exit the setting table via
m
,
e
/Quit or the Quit menu
item, all changes are ignored.