Xylem WTW Multi 3430, Руководство по эксплуатации

Страница: 39 / 134

Operation
Multi 3430
39
ba75865e19 04/2015
4.7.2 Measuring the pH value
Stability control
(AutoRead )
The stability control function (AutoRead) continually checks the stability
of the measurement signal. The stability has a considerable impact on
the reproducibility of measured values. The display of the measured
parameter flashes until a stable measured value is available.
You can start the Stability control manually at any time, irrespective of
the setting for automatic Stability control (see section 4.4.3) in the Sys-
tem menu.
Note
You can prematurely terminate the Stability control function manually
with <MENU/ENTER> at any time. If the Stability control function is pre-
maturely terminated, the current measurement data are output to the
1 Perform the preparatory activities according to section 4.7.1.
2 Immerse the IDS pH sensor in the test sample.
3 Select the pH or mV display with <M> .
15.03.2014 08:00 Info
1 Freeze the measured value with <AR> .
The [HOLD] status indicator is displayed.
2 Using <MENU/ENTER> , activate the Stability control function
manually.
The [AR] status indicator appears while the measured value is
assessed as not stable. A progress bar is displayed and the
display of the measured parameter flashes.
The [HOLD][AR] status indicator appears as soon as a stable
measured value is recognized. The progress bar disappears
and the display of the measured parameter stops flashing.
The current measurement data is output to the interface. Mea-
surement data meeting the stability control criterion is marked
by AR.