Xylem wtw Cond 7110, Руководство по эксплуатации

Страница: 25 / 44

Cond 7110 Settings
ba75927e05 12/2017
25
6.1.2 Cleaning interval
The cleaning interval is set with the measurement settings (see section 6.1
M
EASUREMENT SETTINGS
(
CONDUCTIVITY
), page 24).
The calibration evaluation (sensor symbol) flashes when a valid calibration is
available for a measuring cell and the set cleaning interval has expired.
The flashing calibration evaluation reminds you to clean and calibrate the
measuring cell regularly (see section 5.2.3 D
ETERMINING THE CELL CONSTANT
(
CALIBRATION IN CONTROL STANDARD
), page 19).
It is still possible to measure.
6.1.3 Selecting the temperature compensation
1. Open the calibration menu with <CAL> .
2. If necessary, select the Use tC setting with <CAL> .
3. Press <MENU/OK> or <CAL
_
> to confirm the selection of Use tC .
The set temperature compensation is displayed.
4. If necessary, change the setting of the temperature compensation with
<CAL> .
• nLF : Nonlinear temperature compensation
• Lin : Linear temperature compensation
If necessary, set the linear temperature coefficient with <

><

>.
• ---- : No temperature compensation (temperature compensation
switched off)
5. If necessary, quit the setting of the temperature compensation with
<MENU/OK> .
The set temperature compensation is used.
Temperature compensation
The calculation of the temperature compensation is based on the preset refer-
ence temperature, 20 °C [Tref20] or 25 °C [Tref25].
F
L
n
0 3 5
S/cm m
nLF
Tref25
ARng