INSTALLATION
6
With your tape measure on the outside of the
molding, make a mark on the top and bottom
of the border using a marker.
Cut the mesh with scissors. Use your measuring
tape as a guide as you cut to make sure
you are cutting the mesh at the correct
measurement.
With your cut made, you can now add the edge fabric. Place the mesh between the folds of the
edge and slide the edge down the mesh. Using your stapler, staple it into place with the staples
about 1/4” from the edge of the fabric. Once you have confirmed the mesh is fully inside the border,
cut the excess fabric away from the border.
Next you can attach the pole you removed, to the cut side. First lay your molding strip on top of the
edge you just attached and line up the molding so it is flush with the bottom. Make sure the staples
are covered by the molding and screw a screw into the molding until it comes through both the
molding and the mesh. The molding should be attached with 2 screws and the cut piece of mesh.
Glide the pole underneath the molding and the fabric then line up the screws that come throught
the other side to the parallel holes of the pole. Partly back out your screw while applying pressure
on the molding and the pole. Then slowly drive the screw back down into the pole. Repeat this step
for the bottom part of the pole. Screw in the rest of the screws into the pole. The pole should now be
attached.
LATCHING THE FENCE SECTIONS:
Once the dence sections are installed you are ready to start latching
the fence. Each full section has a pilot hole at the top, between the first and second screw.
1. Using the drill bit, slowly drill out the pilot hole and bevel the hole slightly.
2. Screw on eye into each hole on the opposing sections.
3. Squeeze the poles and clip the double clasp latch on to either screw eye. Follow this step for all
sections.
4. Using the latch for leverage, disconnect the latch from the screw eye and turn the other screw eye.
Make sure both screw eyes are tightened enough that you don’t see any threads. Since the fence
works on tension you have to squeeze the poles together to make sure the poles are straight. Twist the
poles to make sure the are straight before latching them .
