XtremeAIR XA41, Руководство по обслуживанию

Страница: 33 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page date: Page 5
25.09.2018 Chapter 05
05-20-02 First 25 Hour Inspection
For new aircraft, the procedures which are defined in the 50 Hour inspection (Chapter 05-
20-03) must be performed after the first 25 hours of operation.
05-20-03 50 Hour Inspection
Description Action Signature
Canopy
The canopy lock operates correctly CHECK
The canopy moves freely when you open and close it CHECK
The retaining strap is correctly installed CHECK
The hinge pins and the retaining clips are correctly
installed
CHECK
The condition of the canopy glass is satisfactory CHECK
Canopy seal (aircraft with canopy seal) APPLY TALC
Rear seat - Rudder pedal assemblies RH and LH
The pedal assemblies move freely from stop to stop CHECK
The play of the pedal sliders is correctly adjusted CHECK
The AN23-18A bolt is correctly installed in the pedal
axle
CHECK
The split pins are correctly installed in the master
brake cylinder assembly
CHECK
The brake pedal and the master brake cylinder move
freely when you push the brake pedal
CHECK
The brake lines are correctly connected CHECK
The condition of the rudder pedal assembly is
satisfactory
CHECK
The rails and mounting blocks are correctly assembled CHECK
All nuts are safetied CHECK
The length is correctly adjusted. The assemblies move freely
from the most forward to the most aft position
CHECK
The length adjustment lock is correctly assembled and operates
correctly
CHECK
The brake function for “hard pedals” is satisfactory CHECK
Rudder idler assemblies RH and LH
The assemblies move freely from stop to stop
CHECK
The split pins are correctly installed in the castle nuts
CHECK
The rod ends turn freely CHECK