Xtralis VESDA VFT-15, Руководство по эксплуатации продукта

Страница: 15 / 70

VESDA by Xtralis
VESDA VFT-15 Product Guide
www.xtralis.com 9
5. Display LEDs
LED Description
Power Indicates that the power supply is ON.
If the system processor is faulty, the General Fault, Power and Comms LEDs will be
activated simultaneously.
General Fault The detector has one or more faults, which will also be shown by other specific fault
indicators. The Fault relay contacts always follow the state of this indicator.
Isolated will also show as General Fault.
If the system processor is faulty, the General Fault, Power and Comms LEDs will be
activated simultaneously.
Processor
Reset This indicator activates briefly during the powerup initialization sequence.
Mains Fault This indicator may activate due to an incorrect device configuration.
To prevent this from occurring, ensure that Pin 2 and Pin 5 on CN2 are linked.
Refer to page 13 for further information.
Flow Fault The flow rate for any sector is outside the bounds set by the High and Low flow
limits.
Battery Fault This indicator may activate due to an incorrect device configuration.
To prevent this from occurring, ensure that the STANDBY parameter in the
Configuration menu is set to 0. For more information, refer to Table 5-4.
Aspiration
Fault The rotary valve has a fault.
Detector Fault The laser smoke detector has developed a fault.
Isolated This has been put into Isolated mode when the unit functions normally, but alarm
reporting via the relays is disabled.
Note: General Fault will also be shown.
Comms Fault An element of the internal RS485 communication link or remote display is faulty.
If the system processor is faulty, the General Fault, Power and Comms LEDs will be
activated simultaneously.
Hold Flashes when a manual scan is being performed.
Unlock The Panel is unlocked - meaning that an access code has been entered. It will
clear when normal operation is resumed.
Table 2-2: LED Descriptions
6. Alert, Action, Fire1, and Fire2 Indicators
These operate in tandem with corresponding relays on the I/O board to indicate progressive levels of smoke
and are programmable for obscuration level.
7. Logarithmic smoke density bar graph
Displays 0 to 20 % obs/m (0 - 6.09 %obs/ft) with a resolution of 0.001 % obs/m (0.0003% obs/ft) at the lower
end.