Xtralis HeiTel CamDisc HNVR, Руководство по эксплуатации продукта

Страница: 63 / 68

HeiTel by Xtralis CamDisc HNVR Product Guide
26419_04 63
9 Troubleshooting
This chapter will support you in evaluating errors and help you with their elimination.
What to do in the event of malfunctions / sabotage
Malfunction report
The CamDisc HNVR logfile LED on the housing front side indicates malfunctions. In addition, a log entry will
be written to the logfile on the hard disk, refer to "Logfile" on page 41. Moreover, certain messages will be
reported by relay, provided this relay has been configured as an Error relay. The Logfile LED relay indicates
the state of the Error relay for CamControl LITE or CamControl PRO software.
Error / malfunction CamDisc HNVR reaction
Hard disk removal Error will be indicated by the Logfile LED and reported to a
CamControl LITE station (depending on configuration) by
the Error relay.
Error on hard disk access The error will be indicated by the Logfile LED, written to the
logfile on the hard disk (if still possible) and forwarded to a
CamControl station (depending on configuration).
Power failure Error relay opens (if so configured).
Warning for set image threshold reached The condition will be indicated by Logfile LED and reported
by the Error relay (depending on configuration).
With a warning threshold set to <100%, the device will
continue operation until the respective camera track on this
disk is full. Then recording on this track will be stopped until
deletion will release recording again.
Video signal failure The condition will be indicated by the Logfile LED and
reported by the error relay (depending on configuration).
The device is switched off briefly and switched
back on immediately. Fast switching off and on
has the impact of a power failure. Wait for about
10 seconds after switching off the device before
switching it back on again. Error relay opens (if so configured).
General Errors
Frame archiving on the CamDisc HNVR hard disk
Fault Possible causes Remedy
The frame storage
device is full, the
number of images
does not correspond
to the size of the
hard drive The frame storage device
was switched off during
the initialisation process,
e.g. during initial start-up of
a new removable hard
disk. 1. Reinitialise the hard disk
2. Inspect the archive settings in the image archiving
device. Has the desired recording type been
configured? Have the camera tracks been set
correctly?
Frame storage
device cannot be
accessed online,
message under
image: ???/0 No frames archived Record some pictures before attempting to access the
archive. Check the archive settings.