ELECTRIC TOOL HANDLING AND MAINTANCE
ASSEMBLY
CUTTING HEAD RAISING (FIG. A)
1. Push down slightly on the switch handle.
2. Pull out the stop latch (1).
3. Allow the cutting head to rise to the up position.
WARNING!
To avoid injury and damage to the saw transport
or store the miter saw with the cutting head locked in the
down position. Never use the stop latch to hold the cutting
head in a down position for cutting operations.
LOCKING (FIG. A)
When transporting or storing the miter saw the cutting head
should always be locked in the down position.
1. Push the cutting head down to its lowest position.
2. Push the stop latch (1) into the locking hole.
FIG. A
FIG. B
IMPORTANT:
To avoid damage never carry the miter
saw by the switch handle the cutting arm or the miter table
handle. ALWAYS use the designated carrying handle.
INSTALL SIDE HANDLE (FIG.B)
Insert the miter handle into the opening in the miter table.
INSTALL DUST BAG (FIG.C)
1. Squeeze the metal collar wings (2) on the dust bag (1)..
2.Place the dust bag neck opening around the
exhaust port (3) and release the metal collar wings.
• Do not use this saw to cut and/or sand metals. The hot
chips or sparks may ignite saw dust or the bag material.
• To prevent hazard, clean and remove sawdust from
under the saw frequently.
FIG. C
Содержание XT106305
Страница 19: ......
