XTline XT106255, Руководство пользователя, Страница: 34 / 38

WORK CLAMP (SEE FIG C)
1) The work cla mp can be fitted on either side of the saw and is fully adjustable to suit the
size of the workpiece.
2) Do not operate the saw without damping the workpiece.
3) Make sure that the work clamp securing screws are tightened.
MOUNTING HOLES (SEE FIG Dl
Before use, the saw can be fixed to a firm, level surface with the 4 mounting bolts [not supplied).
Four holes are provided in the base of the saw to enable it to be fixed to a bench, or other
supporting surface.
To mount the saw, proceed as follows:
1) Locate and mark where the saw is to be mounted.
2) Drill 4 holes through the surface.
3) Place the sliding mitre saw on the surface aligning holes in base with holes drilled in the
surface. lnstall bolts, washers and hex nuts.
1. RELEASIN6 THE SAW HEAD (SEE Fl6 E1, E2)
When boxed or du ring storage, transportation, the saw head is locked in the down position. To
release the head ready for operation, apply downward pressure and pull out the lock pin [al, then
turn 90°left or right to lock it in place. The head will be raised gently to upper position.
sition.
2. STARTIN6 THE SAW (SEE Fl6 F)
Depress the trigger switch [23]. Allow the motor to reach full speed. When the blade has reached
maximum speed, unlock the blade guard by operating the safety release lever [2] using your
thumb.
3. CHOP CUT (SEE Fl6 61, 62)
Chop cut is used mainly for narrow pieces, i.e. the lock screw of slide rod is tightened and the
head assembly is lowered to cul through the workpiece.
1 l Connect the machine to power outlet, ensure that the mains cable is clear of the blade and
base plate.
2) Position the material to be cul on the rotary table, ensure it is firmly clamped so that it
will not move during cutting.
3) S lide the cutting head to rear position as far as it will go and lock the slide rod by
rotating the slide rod securing knob clockwise.