XTline XT106200, Руководство пользователя

Страница: 27 / 30

EN
ELECTRICAL SAFETY
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your INTOP tool is double insulated
in accordance with EN 60745;
therefore no earth wire is required.
ASSEMBLY AND
ADJUSTMENT
NOTE: Before using the tool,
read the instruction book
carefully. Prior to assembly and
adjustment always unplug the
tool.
Prior to assembly and adjustment
always unplug the tool.
CHANGER THE TOOL
• Loosen the quick—clamping lever and switch it
to the stop.
• Turn the binder plate in anticlockwise direction
• Clean the binder plate the application tool and
the fastening element.
• Place the application tool exactly onto the
star-shaped tool holder. Pay attention that the
application tool has a flush fit.
• Put the binder plate exactly onto the
star-shaped tool holder. turn the binder plate in
clockwise.
• SwiveI the quick-clamping Iever bawck until it
engages.
*
MOUNTING THE SUCTION DEVICE
• To remove the suction device again push the
clamp at the mark to the rear.
DUST/CHIP EXTRACTION
• Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one’s health. Touching
or breathing-in the dusts can cause allergic
reactions and/or lead to respiratory infections of
the user or bystanders.
• Certain dusts, such as oak or beech dust,
are considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
--- Provide for good ventilation of the working
place.
--- It is recommended to wear a P2 filter-class
respirator.
Observe the relevant regulations in your country
for the materials to be worked.
• Prevent dust accumulation at the
workplace. Dusts can easily ignite.
INSTRUCTIONS FOR
USE
Always observe the safety
instructions and applicable
regulations.
Observe correct mains voltage!
The voltage of the power source
must agree with the voltage
specified on the nameplate of
the machine.