3
REGULATORY
FCC C
LASS
A N
OTE
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference in which case the user will be required to correct the interference at his own
expense. Testing was done with shielded cables. Therefore, in order to comply with the FCC
regulations, you must use shielded cables with your installation.
WARNING
This product Complies with EN55022 Class A. In a domestic environment this product may
cause radio interference in which case the user may be required to take adequate measures.
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital
apparatus as set out in the interference - causing equipment standard entitled “Digital
Apparatus”, ICES-003 of the Department of Communications.
Cet appareil num
é
rique respecte les limites de bruits radio
é
lectriques applicables aux appareils
num
é
riques de Classe (A) prescrites dans la norme sur le mat
é
riel brouilleur: “Appareils
Num
é
riques”,NMB-003
é
diet
é
e par le miniistre des Communications.
M
ANUFACTURER
’
S
D
ECLARATION OF
C
ONFORMITY
This equipment has been tested and found to comply with the requirements of European
Community Council Directives 89/336/EEC and 73/23/EEC relating to electromagnetic
compatibility and product safety respectively.
A
TTENTION
This product has been designed and certified to comply with certain regulatory requirements
pertaining to Information Technology Equipment. This product has not been designed for use
as a medical device. Without limitation of the foregoing, this product is not intended and has
not been certified for use in a hospital or clinical environment to diagnose, treat, or monitor
patients under medical supervision, and is not intended and has not been certified to make
physical or electrical contact with patients, nor to transfer energy to or from patients and/or to
detect such energy transfer to or from patients.
