3.8 Turning operation on flat ground or platform
Press
Mode switch
key on the hand-held controller to
switch the climbing machine to the loading board manual
adjustment mode. Operate the joystick to lift and flip the load
board, slightly increase the center of cargo’s gravity, until
the casters completely go off the ground. Then, press
Mode
switch
key again to switch to the track walk mode, and use the
joystick to turn left or right. When the steering is completed
and ready to go up or down the stairs, follow the previous
instructions for going up and down stairs.
Flat ground can be carried out by wheels, through the
mode switch
key cut to the load board mode, the load board flat,
so that the front wheel landing; Then switch to the support
wheel manual mode by
mode switch
key, slightly make the
support wheel landing. When all four wheels are on the
ground, the tracks are off the ground and you can push the
wheels flat.
Note: Flat wheels are not suitable for slopes greater
than 5 degrees. Otherwise it will cause the danger of
landslide. The emergency remedy is to immediately turn on
the automatic mode of the pallet and bring the track to the
ground.
3.9 Parking
NOTE——Use the hand-held controller to power off the
machine, and then turn off the power switch of the battery pack
