1. The waterblock is designed for crossfire setups, so
you can fit the G1/4” fittings to multiple sides of the
block. Decide which configuration is best for your
system.
3. Attach your chosen fittings to the G1/4” ports. Make
sure to attach one of the left and one on the right side.
Flow direction is not important.
2. Use the G1/4” blanking plugs to block the unused
ports.
If you are using cards in crossflow you can use the
optional SLI flow connector to bridge the two cards.
This should be done after step 12.
Optional
4. The block is now ready to be connected to the other
watercooling components for leak testing.
NEXT PAGE
6.
In the next steps the waterblock is shown without tubing
or other watercooling components connected.
This has been done to make it easier to see the
installation process.
Note: This waterblock is only suitable for reference design R9 290X and 290 cards. If you are unsure if your card if a reference design card,
contact us prior to installation to make sure.
Technical Details
- Dimensions: 264 x 125 x 25mm
- Ports: G1/4”
Box Contents
1 x R9 waterblock
5 x G1/4 plugs
8 x 1mm thermal pad
1 x Thermal paste
13 x M3x6mm screw
13 x Red washer
1 x Twin 3mm blue led
G1/4” hose fittings sold separately
XSpc
®
RAZOR R9 290X / 290
www.xs-pc.com/support
