908312
SCH M3x12
908316
SCH M3x16
During assembly, there may be some differential movement in the bulkhead. In
particular, DO NOT check mesh or diff movement without installing suspension
holders and securing bulkhead to the chassis. All parts have specifically designed
tolerances, and only when the car is fully assembled will it have the proper
amount of play where necessary. Check for free movement of all rotational
driveline components once the driveline and suspension are completely
assembled, as well as non-binding operation of the suspension components.
This Upgrade Kit includes reinforced Front & Rear Diff Bulkheads and Diff Height Inserts featuring new Labyrinth Dust Covers. Please follow these supplemental instructions during related assembly steps.
LOWER
Bevel & Differential
LOWER
LOWER
DETAIL
TIGHTEN
3x12mm SCREWS FIRST
TIGHTEN
3x16mm SCREWS SECOND
SUPPLEMENTARY SHEET
LOWER
CENTER
BALL-BEARING HUB POSITIONS
PREVIOUS
NEW
BULKHEADS & HUBS
BULKHEADS & HUBS
UPPER
INITIAL SETTING
Cut off burr
Cut off burr
NEW Labyrinth
Design
NEW Reinforced
Design
NEW Labyrinth Design
EXTREMELY IMPORTANT
HUB MUST BE INSERTED IN
GROOVE AND PROPERLY PRESSED
INTO BULKHEAD.
Check that left and right Diff
Height Inserts are installed in
the same orientation.
THE COVER MUST BE ALIGNED
WITH LABYRINTH GROOVE AND
THEN PRESSED INTO PLACE
INSTALLING THE DIFFERENTIAL WHILE FIRST TIME BUILDING THE CAR
