USER’S MANUAL
MTPADP-BT-EH-SA
Bluetooth®
standalone keypad with integrated RFID reader
1. SPECIFICATIONS
User capacity:
Relays:
Output:
Entry mode:
RFID reading type:
Reading distance:
PIN Code Length:
Power supply:
Buzzer, backlight control:
Tamper:
RS-485 interface:
Door Open Time:
IP Factor:
Operating Temperature:
Operating Humidity:
Firmware upgrade:
Wiegand output:
Programming:
Door operation:
Holidays:
Event capacity:
100 Cards and 100 PIN Codes
1 or 2 depending on the remote relay unit
1 with RTT and RU1 and 2 with RU2 and DINRTT
RS-485, Wiegand
PIN Code, Card, PIN Code or Card
EM 4002/4100 and HID (125kHz)
up to 4cm
6 Digits
12 VDC; max. 100mA
Yes, ON/OFF via XPR Smart Admin
Yes
Yes, for connecting I/O boards like
RU1, RTT, RU2, DINRTT
0 to 255 sec. or toggle (ON/OFF mode)
IP65
20ºC to +50ºC
5% to 95% RH without condensation
Yes, via
Bluetooth®
wireless technology
Wiegand 24, 26, 32, 34, 56, 58 bits
or 4, 6, 8 bit per key for the keypad
via XPR Smart Admin
via XPR Smart Access
24
4000
1
2. MOUNTING
Cable
Ø6.0
3
0
m
m
+12V
gnd
d0
d1
xx
xx
xx
xx
92mm
27mm
51mm
3 (3 x 30mm)
5mm
1 (M3 x 6mm)
v.b8
EN
Access Granted
(Output 1 or 2)
Idle Mode
Access Denied
Tricolor indication LED
3. RESET READER TO DEFAULT
1. Turn the device OFF
2. Put dipswitch 1 to position ON
3. Turn the power ON
4. Wait approx. 15 seconds until continuous beeps.
5. Put dipswitch 1 to OFF
6. Wait for long beep and orange back light led.
The reset procedure will bring the reader to default.
The password will be deleted, all the users and the
reader will be unpaired from the remote relay unit.
Unpairing the reader after reset, prevents
unauthorized reset and keeps the unit in high
security state.
Important note:
The
Bluetooth
reader comes with RU1 remote relay
®
unit.
Make sure to make firmware update with the latest
available firmware.
ON
1
2
R
eset
Service mode