03
04
EN
PYLON 750 BRONZE
PYLON 650 BRONZE
PYLON 550 BRONZE
PYLON 450 BRONZE
Installation
Safety and Agency Approvals
5
7
9
11
12
13
Product Specifications
CONGRATULATIONS ON THE PURCHASE OF YOUR NEW
XPG PYLON BRONZE SERIES POWER SUPPLIES
XPG PYLON BRONZE Series power supplies are created for quiet operation while keeping
an Xtreme power Performance. It features a 120mm Fluid-Dynamic Bearing (FDB) fan
running at extremely low RPM with a fan control circuit design that enables a silent and
efficient operation.
80 PLUS BRONZE rated efficiency ensures a low-cost operation and the fixed cable set
provides user convenience with reasonable length and connector quantity. XPG utilizes only
very high quality 105°C Main Japanese capacitors on all units and it’s a great choice for any
high performance PC that are budget conscious.
SAFETY AND PROTECTION
The main outputs will be latched off when each protection is triggered. The main
output can be reset by cycling the DC remote on/off or AC power. +5Vsb output is auto
recovery when fault condition is removed.
INTEGRATED PROTECTION CIRCUITS
Over Current Protection :
XPG has followed Intel Power Supply Design Guide with 110%-140% of total current
on all+12V & +5V & +3.3V rails. Therefore OCP of XPG PYLON is more effective.
Over Voltage Protection :
OVP on +12V, +5V, +3.3V DC outputs rails are required to comply with the latest Intel ATX
Power Supply Design Guide. OVP shuts down the PSU in the event that the DC outputs
exceed a set level, determined by the PSU manufacturer. The minimum voltage levels
required for compliance is +12V rail@ 15.6V max , +5V rail at 7.0V max, +3.3V rail
at 4.5V max.
Over Power Protection :
XPG has followed Intel ATX Power Supply Design Guide with 110-150% of PSU Total
Wattage.
Over Temperature Protection :
OTP ensures that the PSU will shut down when the PSU internal temperature reaches a set
point. This is usually as a result of internal current over loading or a defect fan.
No Load Operation :
XPG has followed Intel ATX Power Supply Design Guide with 0A minimum loading to
support Intel Haswell C6/C7 sleep mode function.
Short Circuit Protection :
SCP is defined as any output impedance of less than 0.1ohms. Amongst other things, SCP
ensures that the PSU shuts down should the +12V, +5V & +3.3V rails short to any ground,
or any other rail. It also ensures that no damage should occur to your PC components if
there is any short circuit inside the system.
XPG Power Supplies have full protection circuits on board to keep your expensive
components safe under all circumstances.
