Misgav Industrial Park, POB 60, D.N. Misgav 20174, Israel
Tel: +972-4-9951999; Fax: +972-4-9990287
PM0614.02 – XV0500 Video MCU Getting Started Guide
Page
1
of
3
XV0500 Video MCU
Getting Started Guide
Package Contents
XV0500 (2U 19'' width unit)
Short CAT 6 Ethernet cable
USB cable
Power cord
Support hardware for 19'' cabinet
Prerequisites
You need a computer equipped with Internet browser. Firefox is recommended.
Step 1: Power the Unit
1.
For safety reasons, if the line wiring exits the building, it is essential to ground the unit.
Note: Not connecting this device to grounding will void your warranty!
a. Connect a grounding tab to the grounding screw on the rear panel.
b. Using 12-16 gauge wire, connect the grounding tab to a reliable ground.
Figure 1: Grounding Screw on XV0500 Rear Panel
2.
Connect Ethernet interface of the MCU-DSP card to the eth1 interface by using supplied Ethernet
cable.
3.
Connect the unit to the LAN via the eth0 interface.
4.
Connect the power cord to the device and turn on the power using the switch on the rear panel.
The device startup process takes about 2 minutes.
Step 2: Configure or Obtain the IP Settings for XV0500
Please note that eth1 interface and the MCU-DSP card Ethernet interface are pre-configured for
172.16.200.1 and 172.16.200.2 correspondingly. If the 172.16.200.nnn addresses are already in use
on the LAN then it is necessary to change the IP addresses of the MCU-DSP and the eth1 interface in
order to avoid conflict of IP addresses. Please refer to “XV0500 MCU User’s Guide” for further
details.
It is possible to configure or obtain the eth0 and eth1 IP settings by using a keyboard and a display
monitor.
eth0
eth1
Grounding
Power Supply
