Xo FLEX, Руководство по установке

Страница: 20 / 59

XO FLEX – Installation instructions Installation
20
Figure 18 – Adjusting the unit base, (1) adjustment nut and (2) bushing in the floor
ALIGNMENT OF THE UNIT BASE
1. With the special wrench (MG-416), adjust the brass adjustment bushing – (5) in Figure 19 –
in the supporting leg and allow for approximately 10 mm clearance between the supporting
leg and the floor surface.
2. Fit the screw and the washer – (9) and (10) in Figure 11 – in the hole through the adjustment
bushing – (5) in Figure 19 – do not tighten.
3. Turn the adjustment nuts – (1) – (4) in Figure 19 – into the unit base, allowing for
approximately 5 mm clearance all the way between the unit base and the floor surface, and
make sure that all four adjustment nuts are resting on the bushings in the floor. The nuts on
top of the long rods should be loose.
4. Place a spirit level on top of the bridge arm post in the longitudinal direction – (A) in Figure
19 – see Figure 20.
5. Turn the adjustment nut – (2) in Figure 19 – until the post is plumb in the longitudinal
direction and then tighten the nut on top of the long rod.
6. Turn the spirit level to adjust the unit stand in the cross-wise direction – (B) in Figure 19 –
see Figure 21.
7. Turn the adjustment nut – (4) in Figure 19 – counter-clockwise and make sure it does not
contact the bushing in the floor.
8. Turn the adjustment nut – (3) in Figure 19 – until the bridge arm post is horizontal in the
cross-wise direction and tighten the nut on top of the long rod.
9. Turn the adjustment nut – (4) in Figure 19 – clockwise until it contacts the bushing in the
floor and tighten the nut on top of the long rod.
10. Turn the adjustment nut – (1) in Figure 19 – clockwise until it contacts the bushing in the
floor and tighten the nut on top of the long rod.