XK052002 – Tube Strobe Light Kit with Switch Panel
Wiring
1.
Install tubes:
. Drill a ¾” hole where the wires need to pass through the body panel. Feed plugs and wires through the holes
and connect them toegther. Secure the tube onto the mounting location.
2.
Route wiring:
Mount the Switch Panel in a convenient location. Connect the RED wire to the POSITIVE pole of 12V DC
battery or a 12V source inside the cab. Connect the BLACK wire to the NEGATIVE pole or to a chassis ground bolt. Utilizing
the included extension wires, route the output wires to the first tubes on the driver side of the vehicle. Daisy chain the
remaining tubes together from driver side to passenger side.
3.
Optional- Tap signal wires:
The Switch Panel has 4 sensor wires exiting it; black, yellow, blue, and red. These signal wires
automatically trigger a driving function when they receive 12V. The YELLOW wire activates the right turn mode and BLUE
activates the left turn mode. Tap these wires into the positive turn signal wire for each side to utilize this feature. If you are only
using strobe lights on the rear of the vehicle, you can take advantage of the brake and reverse modes. The BLACK wire
activates reverse and the RED wire activates the brake mode. If desired, tap these into the coorresponding wire on your
vehicle.
BLACK – REVERSE
YELLOW – RIGHT TURN
BLUE – LEFT TURN
RED – BRAKE
Switch Box Functions
The Switch Box has 5 buttons to control the strobe tubes. These buttons are SOLID, STROBE, LEFT CHASE,
CENTER CHASE, and RIGHT CHASE. There is a master ON/OFF switch on the side of the Switch Box. Turning the
switch to OFF will cut all power from the tubes and disable any of the signal wire functions (ie right turn signal). Holding
any single button down will turn all tubes off.
SOLID
– pressing this button will turn all tubes solid on.
STROBE
– pressing strobe will activate strobe mode. Press repeatedly to cycle through different strobe patterns.
LEFT CHASE
– press left chase to activate the left chasing mode. This will make the tubes chase from the passenger
side to the driver side of the vehicle.
CENTER CHASE
– press center chase to activate the center chase mode. The tubes will illuminate from the center
and cycle outwards. Please note that if the Switch Box has been synconized for 3 or less tubes, the center chase
mode will be disabled.
RIGHT CHASE
– press right chase to activate the left chasing mode. This will make the tubes chase from the driver
side to the passenger side of the vehicle.
