28
ML605/SP605 Hardware Tutorial
UG669 (v3.0) March 15, 2011
System Design Flow
Adding the Perf_AXI core
1.
In the Project Information Area of the XPS GUI, click the
IP Catalog
tab.
2.
Expand the Project Local
PCores
by clicking the respective
+
. Expand the
USER
by
clicking the respective
+
. Right-click on
PERF_AXI
and select
Add IP
.
3.
Inside the XPS Core Config dialog box, set
C_BASEADDR
to
0x90000000
and
C_HIGHADDR
to
0x9000FFFF
.
The C_MSTID and C_MSTID_WIDTH are dependent on the connection of the
AXI_CDMA master to the AXI interconnect. The C_MSTID_WIDTH is the size of the
signal for both ARVALID and ARREADY signals which depend on the number of
masters connected to the interconnect. Each master uses 1 bit of these signals. The
C_MSTID identifies the master's bit for the ARVALID and ARREAD signals.
•
For ML605:
Set
C_MSTID
to
5
and
C_MSTID_WIDTH
to
6
.
•
For SP605:
Set
C_MSTID
to
2
and
C_MSTID_WIDTH
to
3
.
4.
Click
OK
.
5.
In the Instantiate and Connect IP dialog box, select
User will make necessary
connections and settings
and click
OK
. (Connecting bus interfaces are discussed
later in this tutorial.)