The
carEQ
â
module can be purchased as an accessory. A bypass module is
factory-installed and can be replaced by the
carEQ
â
module. For installation
of the
carEQ
â
equalizer, the scale plate under the top cover has to be
removed.
Before you open the amplifier to exchange the modules,
make sure that it is switched off!
Damage will occur to your speakers
and amplifier, if the module is exchanged during operation!!!
The
carEQ
â
module contains up to 10 independent equalizer bands for the
front and rear channels as an error correction for your specific car model.
Ask your local dealer for a list of car models or get it on our website
www.xetec.de
APPLIED TECHNOLOGIES
• HPAA © by
XETEC
design group GmbH: „High Precision Analogue
Amplifier”, symmetrical State-of-the-Art power amplifier
• X-SMPS © by
XETEC
design group GmbH: „x-Switched-Mode-Power-
Supply”, high efficiency power supply
• VCVS-Filter © by
XETEC
design group GmbH: „Voltage Controlled
Voltage Source”, filters for the crossover networks
• X-protect © by
XETEC
design group GmbH: Highly sensitive protection
circuits
• carEQ © by
XETEC
design group GmbH: Car-acoustical error correction
circuit (for specific car model)
4
5. carEQ
â
(optional accessory)
For
XETEC
Gravity series models 4G-300, 4G-600 and 5G-900 the optional
carEQ
â
equalizer module is available as an accessory
. The
carEQ
â
equalizer
is engineered to optimise your sound system by compensating for the
vehicle´s acoustical problems. Every car model has it´s characteristic acoustical
problems, caused by resonances, reflections and peaks generated by the
shape of the interior, regardless which kind of speakers are used.
These individual curves have been recorded by
XETEC
engineers and
programmed into the
carEQ
â
module, which exactly reverses these errors
for compensation. The result is an enhanced sound quality without the
vehicle´s acoustical errors.
Actually not even the best loudspeakers can reproduce music in a car as
it is, since the acoustical errors are always added.
TECHNICAL DATA
XETEC 5G-900 MK2
RMS Output power @ 4 Ohms:
4x100 W
RMS Output power @ 4 Ohms:
2x200 W in bridged mode
RMS Output power @ 2 Ohms:
4x130 W
Peak output power:
1200 W total
Max input Current (@ 13,8 V):
85 A
Idle current (no signal):
1,4 A
Max Current (@ 13,8 V):
100 A
Fuse:
2x40 A
Total Harmonic Distortion (THD): <0,02%
SNR:
>92 dB(A)
Freq. Response (bypass mode):
5 Hz-30.000 Hz (in bypass mode)
Damping Factor:
>200 (50 Hz)
Stability:
>2 Ohm, (>4 Ohm in bridged mode!)
Input Sensitivity:
250 mV-6 V
Crossover frequencies:
40-200 Hz lowpass, 15-200 Hz
highpass, 10-50 Hz subsonic
Ground lift (balanced / unbalanced)
Subwoofer gain adjust with Bass level controller
Warranty: 1 year (2 years in EU)
Содержание Gravity MK2 5G-900
Страница 1: ......
