Installation and Setup
Xerox
®
WorkCentre
®
6027 Multifunction Printer
71
User Guide
Configuring the Host Access List
The host access list controls access to the printer over LPR or Port 9100. You can enter up to five IP
address/mask combinations, and then select to reject, accept, or turn off the filtering for each IP address.
You can enter a specific IP address and address mask, or you can enter a range of IP addresses and
address masks. If no IP address and address mask is entered in the host access list, there are no
limitations on printer access.
You can allow printing from one specific IP address only. The access list would look like the following
table:
Access List
IP Address
Address Mask
Operation
1
192.168.200.10
255.255.255.255
Accept
You can reject one specific IP address, but allow printing from any other address. The access list would
look like the following table:
Access List
IP Address
Address Mask
Operation
1
192.168.200.10
255.255.255.255
Reject
2
0.0.0.0
0.0.0.0
Accept
The first row of the access list is the highest priority. If configuring a list with multiple rows, enter the
smallest range first. Make the first row the most specific, and the last row the most general.
For example, you can set up the host access list to do the following:
•
Accept printing from a specific network.
•
Reject printing from a particular network mask within that network.
•
Accept printing from one particular IP address within that network mask.
In this example, the access list would look like the following table:
Access List
IP Address
Address Mask
Operation
1
192.168.200.10
255.255.255.255
Accept
2
192.168.200.0
255.255.255.0
Reject
3
192.168.0.0
255.255.0.0
Accept
