How To Set up and Configure the WNA-100 Wireless Network Adapter
Section 1:
Set up and Connect the Adapter to a Computer, Then Configure the Computer to
Communicate With the Adapter
Before the adapter can be connected to a printer, it must be connected to a computer so that it can be configured
to function on a wireless network. The adapter must be configured from the adapter's web interface using an
Internet browser. After the adapter has been connected to the computer, the computer's TCP/IP settings must be
configured to communicate with the adapter.
To set up the adapter:
1.
Connect the antenna to the adapter.
2.
Connect the power supply cord to the adapter, and then plug the power unit into the wall outlet.
Note: Only use the power supply provided with the adapter.
3.
Connect one end of the supplied Ethernet crossover cable to the Ethernet port on the adapter.
4.
Connect the other end of the crossover cable to the Ethernet port on the computer that will be used to
configure the adapter using an Internet browser.
Note: The adapter is not intended for use on a switch or hub. The adapter must be connected directly to
