• If the power cord becomes frayed or worn, replace it.
• To avoid electrical shock and damage to the cord, grasp the plug when unplugging the power cord.
The power cord is attached to the printer as a plug-in device on the back of the printer. If it is necessary to
disconnect all electrical power from the printer, disconnect the power cord from the electrical outlet.
E M E R G E N C Y P O W E R O F F
If any of the following conditions occur, power off the printer immediately and disconnect the power cord from the
electrical outlet. Contact an authorized Xerox service representative to correct the problem if:
• The equipment emits unusual odors or makes unusual noises.
• The power cable is damaged or frayed.
• A wall panel circuit breaker, fuse, or other safety device has been tripped.
• Liquid is spilled into the printer.
• The printer is exposed to water.
• Any part of the printer is damaged.
B AT T E RY S A F E T Y
One or more circuit boards in this printer contain a lithium battery. Do not attempt to repair or replace the lithium
battery. If there is a problem with the battery, contact an authorized service representative to correct the problem.
C
Caauuttiioonn::
If the battery on a circuit board is installed incorrectly, there is a risk of explosion.
The lithium battery in this printer contains Perchlorate Material. For information about the special handling
procedures associated with Perchlorate Material, refer to
https://dtsc.ca.gov/perchlorate/
.
T E L E P H O N E L I N E C O R D
C
Caauuttiioonn::
To reduce the risk of fire, use only No. 26 American Wire Gauge (AWG) or larger
telecommunication line cord.
12
Xerox
®
VersaLink
®
B415 Multifunction Printer Safety, Regulatory, Recycling, and Disposal Reference Guide
