Xerox Telecopier 7017, Техническое справочное руководство

Страница: 46 / 194

REP 2.12 ADF Belt (continued)
Replacement
1. Reinstall ADF belt with dot (on edge of
belt) towards the RH frame.
2. Reinstall remaining components in
reverse order.
3. Ensure ADF belt is properly seated in the
alignment grooves on both the ADF drive
clutch and the ADF idler roller.
REP 2.13 Nudger Solenoid
Assembly
Parts List on PL 2.2
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Remove RH cover (REP 1.2).
4. Remove coupler cover (REP 1.3).
5. Remove LH cover (REP 1.4).
6. If installed, remove A8 store & forward
PWB (REP 5.4).
7. Remove A2 main PWB (REP 5.5).
8. Remove power supply assembly (REP 5.6).
9. Remove CNC PWB assembly (REP 5.10).
10.Remove nudger solenoid assembly.
(Figure 1)
a. Remove screw on top of nudger
solenoid, then remove solenoid.
b. Rotate nudger pawl towards the rear
to remove nudger solenoid plunger.
Replacement
1. If the nudger solenoid assembly was
replaced, discard any spring and nylon
washer with the old solenoid assembly.
NOTE: Document feed problems can occur if
the spring and nylon washer on the solenoid
plunger are reinstalled when nudger solenoid
assembly is replaced.
2. Reinstall nudger solenoid assembly.
a. Rotate nudger pawl towards the rear
to reinstall nudger solenoid plunger.
b. If nudger solenoid assembly is being
reinstalled and spring and nylon
washer were removed during
removal procedures, reposition
spring and nylon washer on plunger.
c. Position nudger solenoid on the
plunger, then on the locating pin.
d. Bias front of nudger solenoid
assembly toward right and rear of
nudger solenoid assembly toward left
as shown in Figure 1.
e. Secure nudger solenoid assembly
with the screw.
3. Reinstall remaining components in
reverse order.
12/88
REP 2.12, 2.13
4-14 Telecopier 7017 / 7017SF
www.printcopy.info
www.printcopy.info