Xerox Telecopier 7017, Техническое справочное руководство

Страница: 24 / 194

RAP 2.3.9 Scanner Test
NOTE: Refer to Figure 1 on the next page for a
diagram of the scan drive system.
1. Open scanner.
2. Clean platen roller, scan idler and scan
drive rollers, and retard pad. (Refer to
1.4.1 Call Completion in Section 1 for
cleaning procedure.)
3. Inspect tension on scan idler rollers and
the platen roller.
a.
Press the end of each roller at the
front and rear.
b. The tension should feel the same at
the left and right.
Y N
| Replace springs.
4. Problem resolved:
Y N
| RAP 2.3.6.
5. Return to procedure which directed you
to this test or go to Final Actions.
RAP 2.3.10 Automatic Document
Feeder Test
1. Open Scanner.
2. Inspect ADF Belt. Belt is clean and
undamaged.
Y
N
| Clean or replace belt.
3. Inspect one way clutch by pushing the
ADF belt toward the front. Clutch allows
belt to rotate freely.
Y
N
| Replace clutch.
4. Rotate belt toward the rear. Clutch does
not allow belt to rotate.
Y
N
| Replace clutch.
5. Inspect document guides by extending
guides to maximum and minimum width.
Guides move freely and are parallel.
Y
N
| Replace Input Tray.
6. Enter Service Mode.
7. Place at least three sheets of paper
(multiple originals) into input tray.
8. Enter Original Feed Test.
a. Press Menu.
b. On the key pad, press 7 then 2. The
display indicates:
72 ORIGINAL FEED
PRESS [START] OR [SCROLL]
9. Press Start.
10. Originals feed one sheet at a time.
Y N
| RAP 2.3.6.
11. Press Stop to end test.
12. Return to procedure which directed you
to this check or go to Final Actions.
12/88
RAPS 2.3.9, 2.3.10
2-14 Telecopier 7017 / 7017SF
www.printcopy.info
www.printcopy.info