Xerox Telecopier 7017, Техническое справочное руководство

Страница: 21 / 194

RAP 2.3.5 The Terminal Does Not
Answer.
1. Phone rings (but does not answer).
Y N
| Go to Step 3.
R X N O T E : C h e c k m a n u a l r e c e i v e i s n o t
selected. Check all Autodialer and System Data
parameters are set correctly (switches, links
and System Data) for your particular country.
2. Replace A10, A2.
3. Disconnect the handset from the
terminal. Disconnect the data cable from
the telephone wall jack. Plug the
handset into the telephone wall jack.
Dial tone is heard.
Y
N
| Inform Customer of telephone line
problem.
4. Reseat connectors, then replace data
cable, A10.
RAP 2.3.6 Mechanical Checkout.
NOTE: The following checks apply to all belts,
gears, pulleys, springs and bearings in these
areas:
• Front and Rear Frames.
• Upper and Lower Scanner.
• Upper and Lower Printer.
1. Remove LH cover.
2. Inspect all drive belts. Belts are in good
condition (not broken, frayed and do not
have surface cracks).
Y
N
| Replace belt.
3. Inspect all shafts. Shafts turn freely.
Y N
| Replace shaft and bearings.
4. Inspect all bearings. Bearings are secure
on shafts and positioned properly in
frame cutouts.
Y
N
| Position bearings in frame cutouts,
replace bearings.
5. Inspect pulleys. Pulleys are secure on
shafts and are not broken.
Y
N
| Replace pulley or E-ring.
6. Inspect upper scanner. Upper scanner
closes and latches.
Y
N
| Replace latch spring, latches.
7. Inspect upper printer. Upper printer
closes and latches.
Y
N
| Replace latch spring, latches or
printer frame.
8. Inspect hold down springs on scanner
shaft bearings. Springs are secure on
bearings and shafts turn freely.
Y
N
| Replace springs.
9. Inspect gears. Gears are secure on shafts
and are not broken. Gears mesh
properly.
Y
N
| Tighten set screw in gear or replace
gear or E-rings.
10. Return to procedure which directed you
to this RAP or go to Final Actions.
12/88
Telecopier 7017 / 7017SF 2-11
RAPS 2.3.5, 2.3.6
www.printcopy.info
www.printcopy.info