![background image](http://html2.mh-extra.com/html/xerox/phaser-8200/phaser-8200_networking-setup-manual_3684143032.webp)
Phaser® 8200 Color Printer
Copyright © 2002 Xerox Corporation. All Rights Reserved.
27
Macintosh EtherTalk Network
(MacOS 8.x/9.x/X, version 10.1)
This section provides installation and troubleshooting steps for Macintosh (MacOS 8 through X,
version 10.1):
■
Quick install steps for MacOS 8.x and 9.x — see page 28.
■
Quick install steps for MacOS X, version 10.1 — see page 30.
■
Setting up the Macintosh Ethernet port for TCP/IP or AppleTalk — see page 30.
■
Macintosh troubleshooting step-by-step — see page 31.
Requirements
■
A workstation with the appropriate driver installed.
■
A working knowledge of the operating system (System 8.0+ or higher) being used on your
workstation.
■
Proper cabling in use to connect your printer to the network.
Enabling EtherTalk
If you use EtherTalk, Macintosh computers do not require IP addresses.
1.
Open the
AppleTalk
Control Panel.
2.
Verify that the
Ethernet
port is the selected network port.
3.
To install the printer driver, double-click the installer on the
Software and Documentation
CD-ROM
.
Perform the next two steps for MacOS 8.x and 9.x.
1.
Open the
Chooser
, select the
LaserWriter
driver.
2.
From the right column of the
Chooser
, select the printer. Click
Create
to create the desktop
printer.
Perform the next two steps for MacOS X, version 10.1 only.
1.
Open
Print Center
.
2.
Click
Add Printer
, select the printer, then click
Add
.
For more details, refer to the infoSMART Knowledge Base at
www.xerox.com/officeprinting/
infoSMART
, Document #2562.