Xerox Phaser 7300B, Руководство по обслуживанию

Страница: 92 / 277

3-76 Phaser 7300 Color Printer Service Manual
Multi-Sheet Pick
1.
Ensure the correct weight and type of media is loaded in the tray. See "Media and
Tray Specifications" on page 1-16 for approved media types and weights.
2. Verify that the media settings at the front panel and the driver settings match the
media loaded in the tray.
3.
Fan the media and reload into the tray.
4.
Use service diagnostics to verify the printer is printing within its environmental
specifications.
5. Ensure the media is correctly loaded in the tray and that the guides fit snug against
the media.
Note: Guides can move away from the media loaded in the tray if
the tray is shut too firmly or closed too rapidly.
6. Clean the pick and feed rollers with a clean, dry, lint-free wipe if debris is visible.
Check the rollers for excessive wear or damaged.
Media Skewing
1. Ensure the correct weight and type of media is loaded in the tray. See "Media and
Tray Specifications" on page 1-16 for approved media types and weights.
2.
Make sure that the media is properly installed in the tray and that the guides fit
snug against the media. For larger size media, use the additional guides located on
the left side of the tray.
Note: Guides can move away from the media loaded in the tray if
the tray is shut too firmly or closed too rapidly.
3. Load a fresh ream of paper, or ensure that the media loaded is not torn, wrinkled,
bent or otherwise damaged.
4.
Check for and remove any debris or obstructions in the paper path.
5.
Verify that the registration rollers are in contact with one another along the entire
length of the roller and that no gaps exist between them.
6. If the problem occurs in only one tray or the MPT:
a.
Clean the pick and feed rollers with a clean, dry, lint-free wipe if
debris is visible. Check for excessive wear or damaged.
b.
Check the tray for dirt, debris or obstructions.
c.
Check the tray for damage.
d.
Replace the tray.