Xerox DP N24, Руководство системного администратора

Страница: 35 / 336

Maintaining the Printer
Chapter 1: Getting Started
❖
1-27
Installing the
Maintenance Kit
The Maintenance Kit is comprised of a Fuser Cartridge, a Bias
Transfer Roll (BTR) and Feedrolls (three for each paper input tray).
(In order to support all possible configurations, fifteen feedrolls are
shipped in each kit.)
The Fuser Cartridge, feedrolls and BTR have average useful lives of
300,000 impressions. At 285,000 impressions, this message will be
displayed at the printer’s Control Panel display:
M a i n t e n a n c e K i t
R e q u i r e d
At 300,000 impressions, this message will be displayed at the
printer’s Control Panel display:
M a i n t e n a n c e K i t
R e p l a c e
At that point or sometime in between the occurrence of the two
messages, install the Maintenance Kit.
All instructions necessary for replacing the Fuser, BTR and
feedrolls are contained in the Maintenance Kit. All these
components are designed to be user installable, however a Olivetti
Service Representative can be called to install the Maintenance Kit
for a fee.
See Appendix A: DP N40 Ordering Information for ordering
information, and Appendix B: Maintaining the Printer for
instructions on replacing the Maintenance Kit items.
Ideally, all three items of the Maintenance Kit should be replaced at the
same time to maintain a consistent maintenance cycle. It is your
responsibility to install the Maintenance Kit to keep the machine in
optimal condition. It is also your responsibility to determine when this
kit installation is required.