Xerox DocuPrint N24, Руководство системного администратора

Страница: 72 / 398

Automatic Tray Switching
2-24
❖
DocuPrint N24, N32, and N40 System Administrator Guide
Tray Sequence Rules
When you define a Tray Sequence, the printer searches
the input trays for the correct size and type of paper for
each job that is submitted.
• If you do not specify an input tray when sending a job
to the printer (e.g., no paper source command is sent,
or the paper source is set to “Auto” in PCL), the trays
included in the Tray Sequence are searched first (in
the sequence order), before other trays not in the
sequence.
• If you specify an input tray when sending a job to the
printer, and that tray is included in the Tray Sequence,
the printer will check that tray for the correct size and
type of paper.
— If the tray contains the correct paper, then it is used.
— If the tray does not contain the correct paper (e.g., it
contains other paper or is empty), the other trays in
the sequence are searched.
- If any of these trays contains the correct paper,
then it is used.
- If any of these trays are set to the correct paper
size and type but all of the trays in the sequence
are empty, then the printer will prompt you to
load paper into the specified tray.
- If no trays in the sequence are set to the correct
paper size and type, then the remaining trays
are searched. If there are no trays that can
satisfy the request, then the printer will prompt
you to load paper into the specified tray.
• If you include “MBF” in the Tray Sequence setting, a
request to feed paper from any other tray in the
sequence will be overridden and the printer will
attempt to feed paper from the 50 Sheet Bypass Feeder
first. If the 50 Sheet Bypass Feeder is out of paper, then
the other trays in the sequence are searched.