Xerox DocuPrint N24, Руководство системного администратора

Страница: 126 / 398

Serial Menu
3-48
❖
DocuPrint N24, N32, and N40 System Administrator Guide
Table 3.12 Serial Menu functions
Menu Item and Function Keystrokes Display
Port Enable
Enable or disable the serial port. The
available values are:
On*
Off
1. Press Menu Up or Menu
Down
until you see:
M e n u s
S e r i a l M e n u
2. Press Item Up or Item
Down until you see:
S e r i a l M e n u
P o r t E n a b l e
3. Press Value Up or Value
Down
until you see:
P o r t E n a b l e =
New Value
4. Press Enter . You will see:
S e r i a l M e n u
P o r t E n a b l e
5. Press On Line . You will see:
R e a d y
Port Timeout
Set the time for determining when to
end an incomplete print job and poll
the next port in the polling sequence.
The available values are:
5 - 300 seconds ( 30* )
This item also causes an implicit job end
such as Control D in PostScript or
<ESC> E in PCL, and invokes the
emulation functions associated with
this action (e.g., formfeed, reset, etc.).
The time changes incrementally by 1
second each time either
Value Up
or Value Down is pressed. Holding
down Value Up or Value
Down
causes continuous scrolling
through the values.
1. Press Menu Up or Menu
Down
until you see:
M e n u s
S e r i a l M e n u
2. Press Item Up or Item
Down
until you see:
S e r i a l M e n u
P o r t T i m e o u t
3. Press Value Up or Value
Down until you see:
P o r t T i m e o u t =
New Value
4. Press Enter . You will see:
S e r i a l M e n u
P o r t T i m e o u t
5. Press On Line . You will see:
R e a d y
Table 3.11 Page 1 of 2