Xerox document centre 235 series, Руководство пользователя

Страница: 172 / 209

Precau
tions and Li
mitations
160
6
6.2
On Using TCP/IP
Be aware of the following precautions and limitations when using the printer with the TCP/IP protocol.
6.2.1 During setup
Setting up at the printer
●
Be very careful in setting IP addresses which are controlled as an entire system. Consult
your network administrator before defining any IP address.
●
Depending on the network environment used, it may be necessary to set up the subnet
mask and gateway address. Consult your network administrator to set up the necessary
items.
● If setting the port to Enable leads to insufficient memory, a message to that effect will be
displayed on the control panel and the port status may be set to Disable automatically. When
this happens, set the ports which are not in use to Disable, change the memory size, or
install more memories.
● Specify the size for the receive buffer memory as required by the environment. If the size of
the receive buffer memory is smaller than the file data to be received, the data may not be
received.
Setting up at the computer/workstation
● Be very careful in setting IP addresses which are controlled as an entire system. Consult
your network administrator before defining any IP address.
● Before setting any network (such as the IP address) to a computer being used under
Network Information Service (NIS), consult the NIS administrator.
6.2.2 During switching power on/off
Take note of the following when switching off the power.
When LPD Spool is set to Memory (spool mode)
All the print data spooled to the printer memory, including print data which is being output, will
be deleted. When the printer is switched on again, the print data will not be found.
However, if the printer is switched off immediately after the print data has been sent, the data
may be stored in the computer. In this case, when it is switched on again, the stored print data
will be printed first even if new print data has been specified.
When LPD Spool is set to Hard Disk (spool mode)
All the spooled print data, including print data which is being printed, will be saved. When the
printer is switched on again, the stored print data will be printed first even if new print data has
been specified.