Xerox document centre 235 series, Руководство пользователя

Страница: 134 / 209

5.3 Common Menu Items
122
Mode
M
e
nu and Common Menu
5
WINS Server Get DHCP Address
Sets whether to obtain automatically the IP Address for WINS server from the
DHCP server. This IP Address is needed in order to use WINS. The candidate
values are:
• Off (default)
The address will be obtained manually. Check with your system
administrator for the address.
•
On
If you change the setting from On to Off, you will need to set the IP address manually
on the screen displayed for setting IP address.
Primary IP, Secondary IP
These items will be available whether you choose Off (manually) or On
(automatically) for Get DHCP Address. If you have chosen Off, enter the value
for these items in the XXX.XXX.XXX.XXX format where XXX is between 000-
255. If the Primary IP is not in effect, the Secondary IP will not be in effect too.
If a wrong IP Address is set, the whole network might be badly affected.
When you are pressing or to change the candidate value, press and hold
on to the button to run the displays continuously. When both of these buttons are
pressed together, the value will be reset to the factory setting.
IPX/SPX
FrameType The following items are to be set when using IPX/SPX Frame Type.
The candidate values are (when the Token Ring board is not installed):
• Auto (default)
Sets the frame type automatically.
•
Ethernet II
Uses the Ethernet specification frame type.
• Ethernet 802.3
Uses the IEEE802.3 specification frame type.
•
Ethernet 802.2
Uses the IEEE802.2 specification frame type.
• Ethernet SNAP
Uses the IEEE802.3/IEEE802.2/SNAP specification frame type.
The candidate values are (when the Token Ring board is installed):
• Auto (default)
Sets the frame type automatically.
•
Token
Uses the IEEE802.5/IEEE802.2 specification frame type.
• Token SNAP
Uses the IEEE802.3/IEEE802.2/SNAP specification frame type.
Menu item Explanation