Xerox document centre 235 series, Руководство пользователя

Страница: 131 / 209

5.3 Common Menu Items
119
Mode
M
e
nu and Common Menu
5
Port9100
(con’t...) PJL
Sets whether to enable the PJL commands sent from the computer. The
candidate values are:
•
Enable (default)
• Disable
Port No.
Sets the port number. The range of setting is between 8000-9999. Default is
9100.
When you are pressing or to change the candidate value, press and hold
on to the button to run the displays continuously. When both of these buttons are
pressed together, the value will be reset to the factory setting.
TBCP Filter
Sets whether to enable the TBCP filter when processing PostScript data.
Available only when PostScript Kit is installed. The candidate values are:
• Enable
• Disable (default)
Connect Time-Out
Sets the time to disconnect after data transmission is disrupted. The range of
setting is between 2-65535 seconds. Default is 60 seconds.
When you are pressing or to change the candidate value, press and hold
on to the button to run the displays continuously. When both of these buttons are
pressed together, the value will be reset to the factory setting.
EtherTalk The following items are to be set when using EtherTalk.
This menu item is available only when PostScript Kit is installed.
Port Status
Sets the port status of the EtherTalk port when the power is switched on. The
candidate values are:
• Enable
•
Disable (default)
If the memory is not enough when the Port Status is set to Enable, it may be set to
Disable automatically. When this happens, either set the Port Status of other ports not
in use to Disable or change the memory allocation.
PJL
Sets whether to enable the PJL commands sent from the computer. The
candidate values are:
• Enable (default)
•
Disable
Menu item Explanation