Default settings for the printer engine
7-26
Guide to Performing Routine Maintenance
Changing the decurler setting
To change the default decurler setting:
1. Load the paper tray with the paper you want to use for a job.
Make the correct selections on the tray for the paper being
used and run a few test prints. If there is too much curl, follow
the remaining steps in this procedure.
2. Access the Tools mode (refer to the section “Accessing the
Tools mode” in this chapter).
3. On the Machine Default 1 screen, touch the Decurler Setup
button. The Decurler Setup screen displays.
Figure 7-25. Decurler Setup screen
4. When a paper tray on the screen is selected, the default
selections for paper weight and paper type are automatically
selected. Touch the number of the paper tray from which the
paper is feeding.
•
The button for paper tray 4 displays only if this optional
tray is connected.
•
The button for 221 - 280 g/m
2
(gsm) displays only for tray
3.
•
Paper tray 3 accepts paper weights from 64 to 280 g/m
2
(gsm). If you select Paper Tray 3 or Paper Tray 4, buttons
for Uncoated and Coated are displayed under the Coating
heading.
Содержание DocuColor 2060
