CAUTION—POTENTIAL INJURY:
When moving the printer, follow these guidelines to avoid
personal injury or printer damage:
• Make sure that all doors and trays are closed.
• Turn off the printer, and then unplug the power cord from the electrical outlet.
• Disconnect all cords and cables from the printer.
• If the printer has separate floor-standing optional trays or output options attached to it,
then disconnect them before moving the printer.
• If the printer has a caster base, then carefully roll it to the new location. Use caution when
passing over thresholds and breaks in flooring.
• If the printer does not have a caster base but is configured with optional trays or output
options, then remove the output options and lift the printer off the trays. Do not try to lift
the printer and any options at the same time.
• Always use the handholds on the printer to lift it.
• Any cart used to move the printer must have a surface able to support the full footprint of
the printer.
• Any cart used to move the hardware options must have a surface able to support the
dimensions of the options.
• Keep the printer in an upright position.
• Avoid severe jarring movements.
• Make sure that your fingers are not under the printer when you set it down.
• Make sure that there is adequate clearance around the printer.
CAUTION—TIPPING HAZARD:
Installing one or more options on your printer or MFP may
require a caster base, furniture, or other feature to prevent instability causing possible injury.
For more information on supported configurations, contact the place where you purchased the
printer.
CAUTION—TIPPING HAZARD:
To reduce the risk of equipment instability, load each tray
separately. Keep all other trays closed until needed.
CAUTION—HOT SURFACE:
The inside of the printer might be hot. To reduce the risk of injury
from a hot component, allow the surface to cool before touching it.
CAUTION—PINCH HAZARD:
To avoid the risk of a pinch injury, use caution in areas marked
with this label. Pinch injuries may occur around moving parts, such as gears, doors, trays, and
covers.
CAUTION—MOVING PARTS:
Indicates a risk of laceration or abrasion injuries from rotating
parts.
CAUTION—POTENTIAL INJURY:
This product uses a laser. Use of controls or adjustments or
performance of procedures other than those specified in the User Guide may result in
hazardous radiation exposure.
CAUTION—POTENTIAL INJURY:
The lithium battery in this product is not intended to be
replaced. There is a danger of explosion if a lithium battery is incorrectly replaced. Do not
recharge, disassemble, or incinerate a lithium battery. Discard used lithium batteries according
to the manufacturer instructions and local regulations.
8
Xerox
®
C235 Color Multifunction Printer
Safety, Regulatory, Recycling, and Disposal Reference Guide
Содержание C235
Страница 12: ...12 Xerox C235 Color Multifunction Printer Safety Regulatory Recycling and Disposal Reference Guide Safety...
Страница 35: ......
Страница 36: ......
