Xerox B215, Руководство пользователя

Страница: 68 / 306

Network Connectivity
Xerox
®
B215 Multifunction Printer
User Guide
68
Configuring SNMP Trap Destination Address Using Xerox
®
CentreWare
®
Internet Services
You can add, edit, or delete IP addresses for Network Management workstations that receive traps
from the device.
1. In Xerox
®
CentreWare
®
Internet Services, click Properties

Connectivity

Protocols .
2. Click SNMP .
3. In the Trap Destination Address section, click Add IP Address .
4. For IP Trap Destination Address , type the IP address of the host running the SNMP manager that
receives traps.
5. Type the
UDP Port Number
.
6. To add the traps, perform the following steps.
•
For
TRAP Community Name
, type a name.
• For
Traps to be Received
, select the type of traps that the SNMP manager receives.
7. Click
Apply
.
SNMPv3
SNMPv3 is the current standard version of SNMP defined by the Internet Engineering Task Force
(IETF). It provides three important security features:
• Message integrity to ensure that a packet has not been tampered with in transit
• Authentication to verify that the message is from a valid source
• Encryption of packets to prevent unauthorized access
Note: When configuring settings in Properties, you will be prompted to enter the Administrator
account user name and password. For information about logging in as an administrator, refer to
Accessing the Xerox® CentreWare® Internet Services Administrator Account .
Configuring SNMPv1/v2c with SNMPv3 Using Xerox
®
CentreWare
®
Internet Services
SNMP version 1 (SNMPv1) is the initial implementation of the SNMP protocol. SNMPv1 operates over
protocols such as User Datagram Protocol (UDP).
SNMPv2c includes improvements in performance, confidentiality, and manager-to-manager
communications over SNMPv1, however it uses the simple-community based security scheme of
SNMPv1.
1. In Xerox
®
CentreWare
®
Internet Services, click Properties

Connectivity

Protocols .
2. Click SNMPv3 .
3. For Allow SNMPv3 with SNMPv1/v2c, select Enable .
4. For SNMPv3, select Enable .
Note: Some options become editable after you enable SNMPv3.