Installation and Setup
For installation and setup information, refer to:
•
Installation Guide
packaged with your printer.
•
System Administrator Guide
at
www.xerox.com/office/B1022_B1025docs
.
IInnssttaallllaattiioonn aanndd SSeettuupp O
Ovveerrvviieew
w
Before printing, ensure that your computer and the printer are plugged in, powered on, and
connected. Configure the initial settings of the printer. On your computer, install the driver software
and utilities.
You can connect to your printer from your computer using USB, or connect to a network using an
Ethernet cable or wireless connection. Hardware and cabling requirements vary for the different
connection methods. Routers, network hubs, network switches, modems, Ethernet cables, and USB
cables are not included with your printer and must be purchased separately. Xerox recommends an
Ethernet connection because, typically, it is faster than a USB connection, and it provides access to
Xerox
®
CentreWare
®
Internet Services.
Note:
If the
Software and Documentation
disc is not available, download the latest drivers at
www.xerox.com/office/B1022_B1025drivers
SSeelleeccttiinngg aa LLooccaattiioonn ffoorr tthhee PPrriinntteerr
• Select a dust-free area with temperatures from 10–30° C (50–86° F), and a relative humidity of
20–80%.
Note:
Sudden temperature fluctuations can affect print quality. Rapid heating of a
cold room can cause condensation inside the printer, and can interfere with image
transfer.
• Place the printer on a level, solid, non-vibrating surface with adequate strength for the weight of
the printer. The printer must be horizontal with all four feet in solid contact with the surface. To
find the weight for your printer configuration, refer to
• Select a location with adequate clearance to access supplies and to provide proper ventilation. To
find the clearance requirements for your printer, refer to
.
• After positioning the printer, you are ready to connect it to the power source and computer or
network.
C
Coonnnneeccttiinngg tthhee PPrriinntteerr
SSeelleeccttiinngg aa C
Coonnnneeccttiioonn M
Meetthhoodd
You can connect the printer to your computer using a USB cable or an Ethernet cable. The method
you select depends on how your computer is connected to the network. A USB connection is a direct
connection and is the easiest to set up. An Ethernet connection is used for networking. If you are
using a network connection, ensure that you understand how your computer is connected to the
network. For details, refer to
34
Xerox
®
B1022 Multifunction Printer
User Guide
