Xerox ApeosPort C6550 I, Руководство администратора сети, Страница: 86 / 132

10 E-mail
84
E-
ma
il
10
8) Select [Exit].
„
If [SMTP] has been selected for the [E-mail Receiving Protocol]
Alias cannot be configured. A user can decide an account name (the left side of the @
mark). An address (the right side of the@ mark) is a combination of a host name and
a domain name.
Example: mymail@myhost.fujixerox.co.jp
z Account name : mymail
z Host name : myhost
z Domain name : fujixerox.co.jp
„
If [POP] has been selected for the [E-mail Receiving Protocol]
Specify a POP user name to an account name (the left side of the @ mark), and a
POP3 receiving mail server to an address (the right side of the @ mark). A user can
decide an alias such as mymail@fujixerox.co.jp
Example: mymail@mb1.abc.fujixerox.co.jp
z Account name : mymail
3
Set the protocol for receiving E-mail.
1) Select [Others].
2) Select [E-mail Receive Protocol] and then select [Change Settings].
3) Select either [SMTP] or [POP3] as appropriate for your environment.
4) Select [Save] and then press [Close].
„
If [SMTP] has been selected for the [Mail Receiving Protocol]
1) Select [SMTP Server Settings] and then set the following items for the SMTP
server.
z [SMTP Server Port Number]
Enter a value in the range from 1 to 65535.
„
If [POP3] has been selected for the [Mail Receiving Protocol]
1) Select [POP3 Server Settings] and then set the following items for the POP3
server.
z [POP3 Server Setup]
Select from [By IP Address] or [By Server Name].
z [POP3 Server IP Address]
Enter if [By IP Address] has been selected for [POP3 Server Setup].
Note • Enter the address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in the
range from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
• When moving to the next value without entering all 3 digits, select [save/select next].
z [POP3 Server Name]
Enter if [By Server Name] has been selected for [POP3 Server Setup].
z [POP3 Server Port Number]
Enter a value in the range from 1 to 65535.
z [POP3 Server Check Interval]
Set the interval for checking the e-mail on the POP3 server.