Xerox 5400N - Phaser B/W Laser Printer, Справочное руководство по обслуживанию

Страница: 233 / 503

204 Phaser 5400 Laser Printer Service Guide
RAP 82 Skewed Image
The image is not parallel to the edges of the print
sheet.
Figure 30 Skewed Image
Table 113 Skewed Image Troubleshooting Procedure
Step Actions and Questions Yes No
1 INITIAL ACTIONS
■
Check the paper tray(s) installation and the paper in
the tray(s).
■
Load fresh, dry paper meeting specification.
■
Check the paper path for staples, paper clips, paper
scraps and/or debris causing obstructions.
■
Ensure the Print Cartridge is properly installed.
2 DUPLEX TEST PRINTS
Run five Test Prints from each paper tray, duplexed if
the printer is so equipped. If not equipped with a Duplex
Module, skip to Step 4 below.
Does the skewed image appear only on duplexed
prints?
Go to
Step 3. Go to Step 7.
3 FUSER INSPECTION
1. Inspect the Fuser Assembly for work parts or rollers.
2. Inspect for obstructions or contamination.
Were any worn parts or rollers, or were any
obstructions found in the Fuser Assembly?
Clean,
repair or
replace the
Fuser
Assembly
[RRP 5.1,
page 288 ].
Go to Step 4.
4
EXIT ASSEMBLY INSPECTION
1. Inspect all rollers, drives and gears in the Exit
Assembly for contamination and/or wear.
2. Check for any obstructions in the Exit Assembly paper
path.
Were any obstructions or worn/damaged parts
found in the Exit Assembly?
Clean,
repair or
replace the
Rear Cover
Assembly
[RRP 1-9]. Go to Step 5.