Xeos Brizo-X, Руководство по оборудованию

Страница: 5 / 14

4
Telemetry Configurations
Iridium Transceiver
The Brizo-X has the option to be equipped with an Iridium satellite transceiver at the factory if
requested. The transceiver can be used to transmit SBD (Short Burst Data) packets for coefficient
transmission. Iridium has global coverage and is suitable for any location. An Iridium data plan is
required to use these features. Contact Xeos Technologies for a plan suited to your needs.
For more details on Iridium, see Appendix C: Iridium Service.
GNSS
The Brizo-X uses GNSS to gather wave data to calculate parameters for wave statistics and
coefficients at programmed intervals. It is a critical component of the Brizo-X of any model.
Local Data Output
Diagnostics
Serial port 1 is the default port for diagnostic output of the Brizo-X. As such, this port displays
operational activity, as well as allows for configuration of the device.
Serial Data
Serial port 2 is used for output of wave height data statistics to connected peripheral devices.
The Brizo will first acquire a GNSS signal to calculate parameters before outputting results.
The default port settings for serial ports are as follows:
Baud Rate 115.2k
Parity
None
Data Bits 8
Stop Bits 1
SDI-12 Data
A substitute for Serial port 2, all SDI-12 communications are transmitted in ASCII, but
operationally outputs the same data as other communication methods.
Port settings for serial ports are as follows:
Baud Rate 1200
Parity
Even
Data Bits 7
Stop Bits 1
SD Cards
Onboard the Brizo-X is one 4GB SD card raw GNSS velocity data. The raw data can be used for
post-processing by the user to further analyze the wave data for spectra, etc.