Xenon 1900, Руководство пользователя, Страница: 145 / 356

4 - 27
Require Output Sequence
When an output sequence is Required , all output data must conform to an
edited sequence or the scanner will not transmit the output data to the host
device. When it’s
On/Not Required , the scanner will attempt to get the
output data to conform to an edited sequence but, if it cannot, the scanner
transmits all output data to the host device as is.
When the output sequence is
Off
, the bar code data is output to the host as
the scanner decodes it. Default = Off.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Multiple Symbols
When this programming selection is turned On , it allows you to read multiple
symbols with a single pull of the scanner’s trigger. If you press and hold the trig-
ger, aiming the scanner at a series of symbols, it reads unique symbols once,
beeping (if turned on) for each read. If using a Granit scanner, the scanner also
vibrates. The scanner attempts to find and decode new symbols as long as the
trigger is pulled. When this programming selection is turned
Off , the scanner
will only read the symbol closest to the aiming beam. Default = Off.
Required
On/Not Required
*Off
On
* Off