Xeda International CEDAX ELECTROFOG EWV8, Инструкция по эксплуатации

Страница: 47 / 84

EWV
- 45 -
USING THE MACHINE ELECTROFOG
6. USING THE MACHINE
6.1 GENERAL WARNINGS
- The number of accidents resulting from the use of
machines depends on many factors that cannot
always be prevented and controlled. Some accidents
may depend on unpredictable environmental factors,
others mainly depend on the behaviour of operators.
- In addition to being properly trained and documented
in the use of the machine, the operator should
simulate a series of test manoeuvres at the first start-
up to locate the main commands and functions.
- Any use of the machine, for purposes other than those
envisaged by the Manufacturer, is to be considered
IMPROPER USE. Only use the machine for the uses
intended by the manufacturer.
- Do not use the machine with safety devices that are
not correctly installed and working efficiently. Failure
to comply with this requirement may pose serious
risks to the safety and health of persons.
DANGER
The machine must NEVER be left unattended
during operation. The temperature at the outlet,
with no aerosol product, can reach 650°C and
cause damage to the machine, stored food
products and compromise the storage rooms.
6.1.a Operator workstation
There are no operator seating positions: the working
position is only with the operator standing in front of the
control panel.
DANGER
The operator must wear the PPE required and
listed in section 3 of this manual.
6.2 PRELIMINARY OPERATIONS
Before starting the machine:
- carefully check that the tools used for installation
or other foreign materials have not been left on the
machine;
- ensure that only authorised personnel are near the
machine;
- check the functional safety and stability of the
machine and, if necessary, check the positioning of
the machine again;
- if the functional safety of the machine is not
guaranteed, do not operate it;
- make sure that the safety system tank is full of water,
up to the maximum level indicated by the arrow; if
necessary, top up by removing the upper cap.
- insert the suction pipe, connected to the pump, inside
the container of the product to be sprayed.