Xeda International CEDAX ELECTROFOG EWV8, Инструкция по эксплуатации

Страница: 31 / 84

EWV
- 29 -
SAFETY ELECTROFOG
3.5 RULES FOR ADJUSTMENTS AND
MAINTENANCE
- Maintain the machine at maximum efficiency and
carry out the scheduled maintenance operations
indicated by the Manufacturer. Good maintenance
will ensure the best performance, longer service life
and constant upkeep of the safety requirements.
- It is forbidden to lubricate, clean and adjust moving
parts.
- During maintenance or adjustment of any parts of the
machine, it is forbidden to use your hands to carry
out operations for which are specific tools available.
- Do not use tools in poor condition or use them
incorrectly, e.g. pliers in place of wrenches, etc.
- Tighten every screw, bolt or locking nut of each
mechanical element that requires adjusting or fine-
tuning, without exceeding the normal tightening
values and without using levers or hitting the
wrenches. Torque wrenches are recommended for
tightening torque control.
- Hazard labels and stickers must not be removed,
concealed or made illegible.
- Maintenance and format change of the machine must
be strictly carried out as indicated in the manual,
with the machine disconnected from energy sources
(electrical, pneumatic, etc.).
- Before carrying out any maintenance and adjustment
work, activate all the safety devices provided and
assess the need to inform the personnel working
and those nearby. In particular, place suitable signs
in the surrounding areas and prevent access to all
devices that could, if activated, cause unexpected
hazardous conditions and risk to the safety and
health of persons.
- Before working on the machine to carry out
maintenance operations, turn the main switch to 0
(zero) OFF, lock it with a padlock and make sure that
all the moving parts of the machine are stopped.
DANGER
The operator who performs maintenance
operations on the machine must turn the electrical
disconnector to “OFF” and padlock it. You must
remove the keys from the padlock and carry them
with you for the duration of the maintenance
operation to prevent a second operator from
inadvertently starting the machine.
DANGER
Before carrying out checks/maintenance on the
machine, wait until it has completely cooled down.
- Maintenance and adjustment operations must be
carried out by authorised persons who must prepare
all the necessary safety conditions and comply with
the instructions contained in the documentation
provided by the Manufacturer.
- Do not perform maintenance and/or adjustment
operations in environments with inadequate lighting.
- All maintenance operations that require specific
technical expertise or special skills must be
carried out exclusively by qualified personnel, with
recognised experience that has been acquired in the
specific field of intervention.
- Replace worn parts with original spare parts. Use the
oils and greases recommended by the Manufacturer.
All these factors will ensure that the machine works
correctly and the expected level of safety.
- Do not dispose of pollutants in the environment. Carry
out disposal in compliance with applicable laws.
- At the end of maintenance or repair work, before
restarting the machine, check that there are no
tools, rags or other material left in the areas near the
moving parts.