Set the 12 and 24 volt low battery indicators SW1 & SW2
Move the jumpers to adjust the RECORD deck selectable power options
Move the battery plate designation order from standard wiring B1, B2, B3.
Setting the Low Battery Indicators
Factory preset: SW1- 24.2 volts, SW2- 13.4 volts
When I set my low battery indicator I keep a few things in mind.
The type of batteries I most commonly use
The length of time I want to keep the system running after the indicator turns on.
Because battery types and sizes may vary for each operator, we allow you to simply adjust the LO battery
indicator to fit your needs. There are two different settings - one for 12 volt camera systems SW2 and one
for 24 volt systems SW1.
To set each LO battery indicator you simply need to turn the 8 position rotary switch label 0-8 that
corresponds to a specific voltage. There are two rotary switches inside the housing and a voltage value
key that shows the rotary switch number and the voltage value it corresponds to (photo below).
Adjusting the RECORDER Voltage Output
. 0B 306
Connector no longer installed.
Two jumpers below allow selection of 4.5V, 7.2V, 9V, or battery voltage for the recorder. To select 4.5V -
9V, the jumper J6 is placed on the top two pins and the voltage selected on J7. To use battery voltage for
the recorder, the J6 jumper is placed over the bottom two pins and the right jumper block is ignored.
10
