XciteRC one16 Series, Руководство пользователя

Страница: 21 / 56

21
One16 series
EN
After the ride
·
Maintenance
-
+
+
After the ride:
1. Switch OFF the vehicle first, then the transmitter (ON/OFF-switch in position O).
2. WARNING: disconnect the drive battery and remove it from the model – fire hazard!
WARNING: the motor of the One16 may get very hot during operation. Allow to cool down minimum 20
minutes before the next start to avoid damage. Fire hazard!
Maintenance
To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING:
Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!